极速赛车在线平台

The ability of a tape to withstand rubbing and still function satisfactorily.

极速赛车开奖结果软件

A means whereby the deterioration of a tape encountered in natural aging may be accelerated and reproduced in the laboratory.

极速赛车稳赚方法

Exposure in a chamber to ultraviolet light, heat, and water whereby the effect of outdoor exposure on a tape can be approximated.

极速赛车7码计划

The bond produced to the backing of the same tape or another tape backing.

极速赛车在线开奖查询

Adhesive that is pulled away from the tape upon removal and remains on the surface to which it has been applied.

极速赛车彩票app

The conveyance of adhesive from its normal position on the tape backing to a surface to which the tape was attached, either during unwind or removal.

极速赛车正规平台

The specific adhesion of a pressure sensitive adhesive to a face material or an anchor coat.

back to top

极速赛车官方登录

A relatively thin flexible material to which the adhesive is applied. Theoretically any material that is reasonably flat, thin, and flexible can be used as a tape backing.

极速赛车在线预测

An occlusive coating applied to the non-pressure sensitive side of a porous backing such as paper in order to provide a satisfactory surface that the pressure sensitive adhesive side can contact when the tape is wound into a roll.

极速赛车官网平台

Penetration through the tape of a coloring material (paint, etc.) onto the surface to which the tape is applied.

极速赛车精准两期计划

Adhesion between the sheets of the plies of rolls of coated material, usually due to extreme conditions of pressure, temperature, or humidity.

极速赛车龙虎开奖结果

The ability of a tape to resist damage when a force is applied evenly and perpendicularly to the surface of a tape.

back to top

极速赛车遗漏

The thickness (as of a sheet of paper) measured under specified conditions. See also THICKNESS.

极速赛车玩法

A webstock that holds a pressure sensitive adhesive, especially used to refer to double-faced or double-coated tapes.

极速赛车人工计划软件

The weight of a coating per unit area. In SI-units expressed as grams per square meter (g/m2).

极速赛车大小

The ability of the adhesive to resist shear stress and splitting. Good cohesion is necessary for clean removal.

极速赛车官网预测

The tendency of a pressure sensitive adhesive to act as a heavy viscous liquid over long periods of time. Such phenomena as oozing and increasein adhesion with time are the result of this characteristic.

极速赛车现场开奖结果

The ability of a tape to retain its original color, particularly when exposed to light.

极速赛车官方走势图

The ability of an elastomeric adhesive, coating, or sealer acting as an insulator to withstand the effects of high voltage discharge. Indications of failure appear as surface cracks.

极速赛车开奖历史记录

The slow movement of the adhesive or backing under shear stress.

极速赛车官方预测

Developing a three-dimensional molecular structure in an adhesive normally activated by heat or irradiation. An improvement in shear resistance, high temperature resistance, and oil or solvent resistance will normally result.

极速赛车在线注册

To alter the properties of an adhesive by chemical reaction, which may be condensation, polymerization, or vulcanization. Usually accomplished by the action of heat and catalysts, alone or in combination, with or without pressure.

极速赛车几点开始

The tendency of paper by itself or in a laminate to bend or partly wrap around the axis of one of its dimensions.

back to top

极速赛车号码开奖

A separation or splitting of the tape such as separation of the backing into two distinct layers, separation between laminations of a tape consisting of more than one backing, separation between filaments and backing of a filament reinforced tape, or separation of the adhesive from the backing.

极速赛车开奖结果大小

The measure of the maximum voltage stress that a single layer of tape can withstand before dielectric failure occurs, the test being carried out under prescribed conditions.

极速赛车软件

That property of a material that relates to the constancy of its dimensions, particularly in relation to external influences such as moisture or temperature.

极速赛车走势

An adhesive application to both sides of a backing.

back to top

极速赛车选号技巧

The peeling back or lifting of the outer edge of an applied tape in a curved manner.

极速赛车3期计划

The tendency for the edge of an adhesive label to lift from a surface to which it has been adhered.

极速赛车人工计划公式

The extensible property of adhesive films or adhesive interfaces to contract and expand in such a manner as to overcome the differential contraction and expansion rates that the bonded adherends may exhibit.

极速赛车龙虎和走势图

An elastic, polymeric substance, such as natural or synthetic rubber.

极速赛车号码

A measure of the tape¹s corrosive effect on an electrical conductor, particularly copper. This is particularly important in the selection of tapes for electrical insulation.

极速赛车微信群

The distance a tape will stretch in the machine or cross direction before breaking under controlled conditions, expressed as a percentage of original length. Elongation is not necessarily an indication of conformability.

back to top

极速赛车网

Any paper, film, fabric, laminate, or foil material suitable for converting into pressure sensitive material stock. In the finished construction this web is bonded to the adhesive layer and becomes the functional part of the tape construction.

极速赛车全天在线计划

When a tape pulls completely from the surface to which it is applied and drops off.

极速赛车2期计划

A weakness resulting from stress created by repeated flexing or impact force upon the adhesive-adherend interface.

极速赛车全天两期计划

Thin, longitudinal yarns or threads of glass, polyester, nylon, or other high strength materials.

极速赛车计划群

A condition sometimes occurring during removal of masking tape in which flakes or particles of paint flake away from the tape backing.

极速赛车注册

The ability of a tape to withstand exposure to flame. Fireproof materials will not burn even when exposed to flame. Flame-resistant (fire-retardant, self-extinguishing) materials will burn when exposed to flame, but will not sustain the burn after the flame is removed.

极速赛车开奖结果助手

Distortion of a roll of tape such that the layers no longer form a circle.

back to top

极速赛车开奖人工计划

Openings between layers of tape within a finished roll.

极速赛车计划网

A light reflection characteristic of tape backings, usually expressed by such terms as glossy, low gloss, matte, etc.

back to top

极速赛车娱乐平台

An adhesive film intended to be reactivated by the application of physical or chemical changes caused by exposure to high temperatures.

极速赛车开奖软件下载

A term referring to the process of unwinding or dispensing of tapes at a relatively high rate of speed, usually over 15 meters / minute.

极速赛车最快开奖平台

The ability of a tape to resist static forces applied in the same plane as the backing. Usually expressed in a time required for a given weight and length of tape to shear free from a vertical panel.

极速赛车开奖号码

A pressure sensitive adhesive, applied to the backing in hot liquid form, which then cools to form a conventional pressure sensitive adhesive.

极速赛车官网开奖结果

The moisture content of the air. Actual humidity is the number of grams of moisture in the air at any given time. Relative humidity is the percent of moisture relative to the maximum that air at any given temperature can retain without precipitation.

极速赛车历史开奖

A tendency of some materials to readily absorb moisture from the atmosphere.

back to top

极速赛车计划

The ability of a tape to resist sudden impacts, pulls, or shocks as may sometimes be encountered by packages in transit.

极速赛车官方下载

The ability of tape to prevent the flow of electrical current across its surface, usually measured on the backing.

back to top

极速赛车全天开奖

Pressure sensitive insulation. materials furnished in roll or sheet form with liner, which can be later printed, frequently die cut, and intended for use as labels.

极速赛车开奖视频

A joint made by lapping one material over another to provide a mated area that can be joined with an adhesive.

极速赛车最新注册

A stain in a surface to which tape has been applied, which does not become noticeable until some time after the tape is removed, usually after the surface has been exposed to sunlight or heat.

极速赛车下载

A situation where a section of tape has pulled away from the surface to which it has been applied.

back to top

极速赛车开奖直播下载

Thin flexible sheets of metal, such as aluminum, copper, and lead, used as tape backings because of their inherent properties such as weather resistance, electrical conductivity, reflectivity, etc.

极速赛车规则

A measure of the rate of water vapor transmission through a pressure sensitive product usually measured in grams / square meter / 24 hours.

back to top

极速赛车开奖记录

A roll of tape in which the layers are in correct alignment, but the tape is displaced sideways on the core.

极速赛车开奖结果直播

A “squeezing out” of the adhesive from under the backing. Occurrence when a tape is in a roll form causes the edges of the roll to become tacky.

极速赛车全天计划单期

The ability of a tape to prevent the transmission of light.

极速赛车计划软件

The release of volatile components under heat or vacuum.

back to top

极速赛车开奖走势

A term that refers to the width and spacing arrangement of strips of adhesive laid down parallel to machine direction and across the width of pressure sensitive stock during its production.

极速赛车官方

The force per unit width required to break the bond between a pressure sensitive adhesive tape and the surface to which it has been applied when the tape is peeled back at a controlled angle at a standard rate and condition.

极速赛车计划软件

The softening of an adhesive when exposed to migrating plasticizers or oils.

极速赛车开奖号

A term commonly used to designate a distinct category of adhesive tapes and adhesives which in dry form (solvent / water free) are aggressively and permanently tacky at room temperature and that firmly adhere to a variety of dissimilar surfaces upon mere contact without the need of more than finger or hand pressure. These products require no activation by water, solvent, or heat in order to exert a strong adhesive holding force toward such materials as paper, plastic, glass, wood, cement, and metal. They have sufficient cohesive holding power and elastic nature so that, despite their aggressive tackiness, they can be handled with the fingers and removed from smooth surfaces without leaving a residue.

极速赛车网上

Application of a thin layer of adhesive-like material to a backing that serves as a bonding agent between the backing and the final adhesive coat.

back to top

极速赛车最快开奖

see TACK.

极速赛车开彩结果历史

A web of sheet material used as a protective liner, which covers the adhesive side of the tape. It is removed prior to application. Most frequently found on double- sided tapes and label stocks.

极速赛车历史记录查询

The measure of the force required to separate a unit width of pressure sensitive tape from a release coated surface at a controlled angle and speed.

极速赛车冷热号统计

The operation of winding the webstock from the reel onto a core to produce rolls of the desired width, diameter, and tension.

极速赛车最新开奖号码

A smooth paper made wholly or largely of hemp fiber for tensile strength.

back to top

极速赛车计划

Adding materials (saturant) to the backing for improvement of physical properties and resistance to various deleterious environments.

极速赛车历史结果

An adhesive joint that is accomplished by coating both adherend surfaces, and bringing them under pressure; an elastomeric adhesive (cohesive) used on envelope flaps, box closures, etc, whereby the adhesive film will bond only to itself.

极速赛车网站

The time required, under specified test conditions (surface area, weight load), to slide a standard area of pressure sensitive tape from a standard flat surface in a direction parallel to the surface.

极速赛车官网开奖历开奖结果

The force required to separate a bond by shear force after immersion in a typical varnish solvent under designated conditions.

极速赛车开奖视频直播

A tape to which a pressure sensitive adhesive is applied to only one side of the backing.

极速赛车开奖结果查询

See RELEASE LINER.

极速赛车官网登录

When the tape tears or breaks into small pieces, either on unwind or on removal from a surface.

极速赛车官方开奖直播

The force required to remove a unit width of pressure sensitive tape from a standard panel after it has been in contact with a release liner for a given period of time. This must be compared with the adhesion of the same tape that has not been in contact with the release liner to determine the degree of loss of adhesion.

极速赛车开奖结果时间

The measure of surface tension in dynes. The lower the surface energy of a substrate, the more difficult it becomes for an adhesive or coating to wet out that surface.

极速赛车走势图分析

Any method of treating a polyolefin so as to alter the surface and render it receptive to inks, paints, lacquers, and adhesives such as chemical, flame, and electronic oxidation.

back to top

极速赛车网页计划

The property of a pressure sensitive adhesive that allows it to adhere to a surface under very slight pressure. It is determined by the ability of the adhesive to wet quickly the surface it contacts.

极速赛车结果官方

The force required to propagate a tear in a tape in a given direction after the tear has been initiated.

极速赛车技巧

A sideways sliding of the tape layers, one over another, such that the roll looks like a funnel or a telescope, usually occurring over a period of time.

极速赛车单双

The force required to break a unit width of tape by controlled pulling on opposite ends of the piece.

极速赛车大小玩法

The perpendicular distance from one surface of either a tape, backing, or adhesive to the other, usually expressed in mils, thousandths of an inch, or millimeters. This is usually measured under controlled slight pressure with a special gauge.

极速赛车计划网

A pressure sensitive adhesive unsupported applied to a two-side release coated liner.

back to top

极速赛车官方开奖

The force required to remove tape from a roll under prescribed conditions.

极速赛车官网注册

The weight of water transmitted through a controlled area of tape under a specified time and conditions.

极速赛车免费计划

The weight of water vapor allowed through a controlled area of tape within a specified time period and under controlled conditions.

back to top